Serial Adapter Board for Z-Wave

The ZME_SERIAL is a little daughter board that connects a serial interface to the Wireless Z-Wave networks. The interface to the host is done by a 5x1 jumper connector that can be used in normal position and upside down. The pinout is (3.3V, TXD, RXD,GND, NC). The connection to the antenna is done using a reverse pigtail connector. The module itself contains a Z-Wave 300 chip preloaded with a Z-Wave.Me Z-Wave firmware and a 32 K EEPROM. There is an additional 2x5 pin programming connector compatible to the 2x5 connection of the Sigma Designs Programmer. 
The firmware implements a superset of the Sigma Designs Serial Interface including some Z-Wave.Me specific  functions such as backup and restore or change of Vendor ID.